How can I apply a label starting at a specific point on the container? (AP362 ONLY!)
On units with serial numbers greater than 2091000131 you can change the mode of the container roller using the instructions below.
Set the Mode of the Container Roller Motor:
By default the container rollers continue to spin after every application. This is done to increase application speeds. However, when using this method it is not possible to apply the label at a specific point on the container. To do this you can put the unit in Stop After Apply mode.
See the instructions below:
Run After Apply (Default):
1. Turn off the unit.
2. Press and hold the Recall button with the ‘+’ key and turn on the unit.
Stop After Apply:
1. Turn off the unit.
2. Press and hold the Recall button with the ‘-’ key (minus key) and turn on the unit.