What are the Signature Printer Stand or Accent Stand Dimensions?

What are the Signature Printer Stand or Accent Stand Dimensions?

Since the printer stands for many Signature printers may no longer be available, you can construct a replacement using the dimensions of the originals listed below.  With all of these stands the most important dimension is the height.  The original stand may have hooked into or onto another product.  This is not essential.  Also the stand might have had pins that corresponded to holes on the bottom of the printer.  These pins were only to aide in initial placement of the printer.  They were not essential.

Stand for Signature Z6, Signature Pro or Signature IV connected to a Composer Pro/Plus/XL

Height 2 7/8" (74 mm)
Width 12" (305 mm)
Depth 11 1/8" (282 mm)

Inscripta Stand for connecting to a Composer Pro/Plus/XL

Height 2 7/8"(74 mm)
Width 7 1/4" (159 mm)
Depth 10 3/4" (273 mm)

Accent Stand for connecting to ADL-100

Height 5 13/16" (148mm)
Width 12" (305 mm)
Depth 14" (356 mm)

Accent Stand for connecting to a Composer Pro/Plus/XL in Stand Alone mode (no computer - laminate only)

Height 2 5/16" (59 mm)
Width 12" (305 mm)
Depth 12 3/4" (324 mm)

See this manual for setup instructions.

Accent Stand for connecting to a Composer Pro/Plus/XL in Full Production mode (with computer - burn, print and laminate)

Height 1 7/16" (36 mm)
Width 12" (305 mm)
Depth 12 3/4" (324 mm)

See this manual for setup instructions.

Accent Stand for connecting to Composer MAX

Height 2 1/4" (57 mm)
Width 8 11/16" (220 mm)
Depth 11 3/4" (298 mm)

See this manual for setup instructions.